dylan08
New member
- 4
- 0
- 1
- Location
- Houston, Texas
Hi I am working on my M35 air compressor. I have the wrench that fits the front but i dont know what size goes on the back side to hold it. any help would be greatly helpful. Thank you.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
compressor wrench size
- Thread starter dylan08
- Start date
bottleworks
New member
- 920
- 2
- 0
- Location
- Central NC
Here is a PDF of the wrench. I believe it is to scale and should be traceable on to some plate steel.
Edit: You already have that one...Nevermind.
Edit: You already have that one...Nevermind.
Last edited:
dylan08
New member
- 4
- 0
- 1
- Location
- Houston, Texas
Yes I have the front wrench but was wanting to buy the right one for the rear that holds the pully still. did not want to guess wrong and hoped one of you would know the right size. 
thanks again for any help
thanks again for any help
saquishmike
Member
- 126
- 0
- 16
- Location
- Marshfield mass
I think its 1 13/16"
JDToumanian
Active member
- 1,655
- 14
- 38
- Location
- Phelan, CA
Just get a huge adjustable wrench... My 2" Crescent fits it fine.
dylan08
New member
- 4
- 0
- 1
- Location
- Houston, Texas
Thanks for all the help also found it in tm 9-2320-209-20-3-2 if any one is looking for more info on the compressor.
jmoylan69
New member
- 51
- 0
- 0
- Location
- crescent valley, Nevada
Where can you get that special wrench. and on my 52 REO the compressor pulley feels like its Rusted up pretty solid. anyone have any luck breaking them free??
jmoylan69
New member
- 51
- 0
- 0
- Location
- crescent valley, Nevada
Perhaps I miss spoke, I need info on the air compressor systems for the 52 gasser. anyone know which manual those are covered in? my truck that i just got home last night has a operator manual of TM9-819..would it be in there? and then i'd need know where to get the manual.
- 12,195
- 325
- 0
- Location
- gainesville, ga.
jmoylan69
New member
- 51
- 0
- 0
- Location
- crescent valley, Nevada
LOL I should have known. someone else pointed me to Jatonkas web site and i even bookmarked it. I should have remembered that one.
thanks man.
Best regards to all.
Joe