jonstine
New member
- 29
- 0
- 0
- Location
- Austin, TX
I am replacing the rotors on my 1986 M1028. I have disassembled/pulled everything, and I'm now trying to put the new wheel bolts/studs back in to the hub and rotor. I bought new Dorman 610-283 bolts (which are spec'd on multiple sites as correct), and I can pound them almost the entire way in. The last 1/4 inch isn't going, even with a 4lb hammer and a fair amount of putting my back into it.
Looking at the new vs old bolts, I notice a slight difference, which may account for them not fully seating. See pic.
Are these the correct wheel bolts, and I just need to have them pressed in, or is there a part number for the old style bolt that someone's aware of? I did a search for "wheel stud bolt" on here, and while there are plenty of discussions, I couldn't find one referring to this issue or the correct part. Thanks in advance for the assist.
Looking at the new vs old bolts, I notice a slight difference, which may account for them not fully seating. See pic.
Are these the correct wheel bolts, and I just need to have them pressed in, or is there a part number for the old style bolt that someone's aware of? I did a search for "wheel stud bolt" on here, and while there are plenty of discussions, I couldn't find one referring to this issue or the correct part. Thanks in advance for the assist.