Cowl Weather Stripping?

[dabtl]

Where can I get the cowl weather stripping?

 

[m816]

What do you mean by cowel weather stripping? As far as I know there is a strip between the Hard top and the windshield frame and another strip between the bottom of the windshield where it hinges but that is all that I am aware of. The seam at the end of the cowel and the windshield frame is welded with a flange on the inside. Any leaks there are caused by rust. I Would go to a hvac supplier and buy foam strips in a roll. It has adhesive on one side and makes a water tight seal. Lasts a long time and is superior to solid rubber as far as I can see. It also comes in several widths. Hope this helps. I recently cut out the rusty portion from my five tom cowel and replaced it with new steel. I'm satisfied with the results No leaks.

 

[dabtl]

There was a webbing about an inch wide at the cowl where the back of the hood closed down.

 

[butch atkins]

ORD 9-G-749 pg 470 part # YT-2281306,ANTI-SQUEAK,cotton,3/16 thk.1" wide 75" 1/4lg.(cowl hood ledge). This is straight from the ORD-9 manual,also same matl is used where the cowl bolts to the front of the door frames ,it is 131 3/4 long, part # 2281260. Hope this helps

 

[zout]

Would you get a pic of the area you want to seal so we can help you further please.

 

[nattieleather]

I would try one of the canvas suppliers like Weebee or Beachwood. That is a common webbing used on many MVs.

 

[hndrsonj]

Would you get a pic of the area you want to seal so we can help you further please.

The rear lip of the hood sits on it when closed. Any of the big suppliers should have it.

 

[dabtl]

It is 1/8 thick and six feet long on the cowl. I found it early yesterday.