Crossover pipe repair piece? M1097

[PaulbusMax]

So, i have a crossover/Y pipe i removed from the hmmwv in order to facilitate engine removal. One of the flared pipe ends is disintegrated but the remaing pipe is fine. Does anyone know of a replacement weld on repair piece? I’ve seen a few doing a search but wrong size pipe. Thank you

 

[Mogman]

Not likely, just replace the entire piece.
You may be able to find a good used one, I have a couple laying around here, more trouble to ship than they are worth.

 

[PaulbusMax]

Not likely, just replace the entire piece.
You may be able to find a good used one, I have a couple laying around here, more trouble to ship than they are worth.

The cheapest I’ve seen was $200 plus shipping, thanks for the reply!

 

[Vapor Trail]

I have one off of a 6.5 NA M1123. I'm not sure if it will fit but I'll sell it if you want it.

 

[PaulbusMax]

I have one off of a 6.5 NA M1123. I'm not sure if it will fit but I'll sell it if you want it.

Can you take a picture of it?

 

[Mogman]

AFAIK they are all the same for the 6.2 and 6.5L NA

 

[PaulbusMax]

Can you take a picture of it?

How much would you sell it for? Or should we discuss this, I don’t want to run afoul of the rules.

 

[Vapor Trail]

I’d probably do 125 plus shipping. It’s in very good condition.

 

[juanprado]

The originals are subject to rust/rot. I had to replace mine. Flange and pipe broke off on both ends.
There is a revision in the design for newer ones. My new one is marked REV A. I suspect the metal content is different. 86humv informed us in another thread there is a galvanized and stainless pipe versions.

 

[PaulbusMax]

I’d probably do 125 plus shipping. It’s in very good condition. View attachment 879177

Definitely lots better than mine. I’d be happy to take you up on your offer.