HI,
M925A2. Here is what is happening, when the ctis cycles on first time start up it blows out the quick exhaust valves as it should (nice and loud) but when you drive it a bit the blow offs get very weak on the CTIS Quick release valves when the system does the normal 15 min cycle. (it barely hisses out) and being it can not blow off properly 4 or 5 light codes blinks on the ctis control module. I know there is an air pilot that runs the quick exhaust valves (all 3 of them). Happens the same way going from hwy to XC mode. Have the schematic but seeing if someone else has had the same issue. It is more of a hiss of air instead of a HOOONNNNKKK sound like it should be. something is not shifting properly. it is cold out but still should work you would think. 10 degrees.
Replaced the air dryer just because it should be done with these trucks with the same result.
M925A2. Here is what is happening, when the ctis cycles on first time start up it blows out the quick exhaust valves as it should (nice and loud) but when you drive it a bit the blow offs get very weak on the CTIS Quick release valves when the system does the normal 15 min cycle. (it barely hisses out) and being it can not blow off properly 4 or 5 light codes blinks on the ctis control module. I know there is an air pilot that runs the quick exhaust valves (all 3 of them). Happens the same way going from hwy to XC mode. Have the schematic but seeing if someone else has had the same issue. It is more of a hiss of air instead of a HOOONNNNKKK sound like it should be. something is not shifting properly. it is cold out but still should work you would think. 10 degrees.
Replaced the air dryer just because it should be done with these trucks with the same result.