I am in the process of adjusting the fuel screw on the injection pump. However, I am trying to remove the guide stud and it is putting up quite the fight. I’ve put a lot of force on it and it still hasn’t broke free, and now my allen is fitting loose. It’s not quite stripped yet but I don’t think I have many moves left.
Any suggestions on getting this loose? I didn’t think the IP fuel adjustment was going to cause me problems so Ive already installed the pump. But as I’m adding the turbo I believe I either have to figure out how to make the adjustment or get a different pump which allows me to.
Seems like lately if something can go wrong it will go wrong.
Any suggestions on getting this loose? I didn’t think the IP fuel adjustment was going to cause me problems so Ive already installed the pump. But as I’m adding the turbo I believe I either have to figure out how to make the adjustment or get a different pump which allows me to.
Seems like lately if something can go wrong it will go wrong.