• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Deuce driving tips

wb1895

Member
876
17
18
Location
Lexington NC
I was just wondering what driving tips/ experience you guys might have to share about driving your deuce/ 5 ton.

Heres a couple that I know of:

1. Dont drive a deuce with your thumbs on the inside of the steering wheel: If the wheel gets away from you it will break your thumbs.

2. Make sure your feet are not under the springer seat as you are driving: If you hit a bump the seat will drop and squish your heels/ foot.
 

wb1895

Member
876
17
18
Location
Lexington NC
I was just wondering what driving tips/ experience you guys might have to share about driving your deuce/ 5 ton.

Heres a couple that I know of:

1. Dont drive a deuce with your thumbs on the inside of the steering wheel: If the wheel gets away from you it will break your thumbs.

2. Make sure your feet are not under the springer seat as you are driving: If you hit a bump the seat will drop and squish your heels/ foot.

I should mention that I do have personal experience with both of these issuesaua
 

pad_cdr

Member
151
4
18
Location
Des Moines/Iowa
It won't quite break your thumbs, but it will hurt like he!! for a couple of weeks.

Off road or on mud roads, especially narrow ones, stay on top of your wheel. Unlike a jeep or a 4wd truck, the momentum of a deuce going sideways is hard to overcome. Better to not get going sideways in the first place.
 

wb1895

Member
876
17
18
Location
Lexington NC
It won't quite break your thumbs, but it will hurt like he!! for a couple of weeks.

Off road or on mud roads, especially narrow ones, stay on top of your wheel. Unlike a jeep or a 4wd truck, the momentum of a deuce going sideways is hard to overcome. Better to not get going sideways in the first place.

My right thumb would disagree with you on that. My first deployment I hit a pot hole while driving a deuce and broke my right thumb.:shock:
 

pad_cdr

Member
151
4
18
Location
Des Moines/Iowa
Before you come to a full stop, be sure your front wheels are pointing the way you want to go when you start up. Armstrong steering is not the best when you are not moving.
 
Last edited:
748
5
18
Location
Woodstock, GA
Keep your elbows tucked, contact with the door takes months to heal.
I can atest to this as I learned that lesson the hard way.

A few of my own tips:
Be sure to leave yourself plenty of stopping distance.
Always have an out.
Ensure that your tires are properly inflated.
Wear your seatbelt.
Don't forget to turn off your blinker.
Don't forget to release and set your parking brake.
Don't use the throttle control as a cruise control.
Properly secure any load you are hauling.

Oh yeah, and don't "drive it like you stole it".
 
Last edited:

NDT

Well-known member
Steel Soldiers Supporter
10,458
6,531
113
Location
Camp Wood/LC, TX
If you are running NDCC tires and it rains, braking on pavement is about the same as braking on ice.
 

sandcobra164

Well-known member
2,999
295
83
Location
Leesburg, GA
Check your brakes before getting underway. Your Master Cylinder is under that little "trap door" on the driver's side, verify that you have BFS in it. Check for leaks to ensure you still have oil in your transmission, transfer case, motor, etc. If everything is dry on the outside, it probably has nothing inside. Close your air tank drains (you drained them when you parked right?) Get in and enjoy the ride. Good tips on the thumbs, following and slowing distances. Lastly, don't get talked into pulling a 23,000 pound load behind you. It has and can do it but it'll be slow going and is more worry than it's worth!!!
 

Heath_h49008

New member
1,557
102
0
Location
Kalamazoo/Mich
Any tire that won't hold air is about to blow.

Any new slight pull in the front end is a tire going flat and getting ready to blow.

Blowing a steer tire on the highway isn't fun.

Start doing upper body weight lifting to control that wheel when it gets a mind of it's own.

Buy and keep a selection of brass fittings and spare line in the tool box as well as cribbing capable of holding the weight of the truck if you go down in soft stuff.

Break all the rear lug nuts loose when you have the time and not the need, so when you get a flat you don't "discover" the rust seized one on the flat you need to take off.
 

Floridianson

Well-known member
Steel Soldiers Supporter
7,409
2,503
113
Location
Interlachen Fl.
Always figure that green light is going to go red. If you are in high range comming to a stop just before the tires stop rolling switch the transfer case to low.
 
Last edited:

135gmc

New member
307
0
0
Location
St Paul/MN
Assume that every person driving a car near you is a lunatic - that way, you won't be surprised at about anything they do. Many years ago, I was towing a 155 howitzer, and had just come onto a freeway from an entrance ramp. The person driving behind me HAD to get in front of me. Since the lane next to me was full, the moron decided to pass me on the shoulder.
 

wb1895

Member
876
17
18
Location
Lexington NC
All of these tips are great!! Keep them coming

For those of you with a winch truck, Make sure the winch is not engaged before you start the truck. The lock out plate has a tendency of flipping up.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks