misterbill64
Member
- 51
- 2
- 8
- Location
- Buckhannon WV
I read a lot of posts on here about different ways of removing a deuce transmission, and liked the thought of a cross post from the dash to rear of cab, well while gathering parts for the transmission I thought I might try to come up with abetter mouse trap so to speak. I took a piece of 2 ½ outer diameter pipe I had laying around cut it to length and welded a piece of angle iron on each end tolay on the cab. I have a hard top so I made it just fit between the center windshield post and the hard top, that makes it so it can’t move back and forth, angle iron won’t let it roll. Then I took a piece of ¼ steel and bent it around the pipe, took a 3” caster wheel and bolted it in the u saddle then drilled and put an I bolt in the center. I hooked a chain hoist to the I bolt to raise and lower it, and it rolls back and forth on the pipe. Total cost was 19.00 at lowes for a caster, ¼ steel, and an I bolt.
![DSCN2802.jpg DSCN2802.jpg](https://www.steelsoldiers.com/data/attachments/318/318071-ddcc64bbb1c203a64ddc41965f247995.jpg)
![DSCN2803.jpg DSCN2803.jpg](https://www.steelsoldiers.com/data/attachments/318/318072-698464412273ce610522534e9e8c88ee.jpg)
![DSCN2804.jpg DSCN2804.jpg](https://www.steelsoldiers.com/data/attachments/318/318073-e7384628f3d56bb2aa12efb375bb2d16.jpg)
![DSCN2805.jpg DSCN2805.jpg](https://www.steelsoldiers.com/data/attachments/318/318074-f9405953d0c013e0b182f78e635d0ed0.jpg)
![DSCN2802.jpg DSCN2802.jpg](https://www.steelsoldiers.com/data/attachments/318/318071-ddcc64bbb1c203a64ddc41965f247995.jpg)
![DSCN2803.jpg DSCN2803.jpg](https://www.steelsoldiers.com/data/attachments/318/318072-698464412273ce610522534e9e8c88ee.jpg)
![DSCN2804.jpg DSCN2804.jpg](https://www.steelsoldiers.com/data/attachments/318/318073-e7384628f3d56bb2aa12efb375bb2d16.jpg)
![DSCN2805.jpg DSCN2805.jpg](https://www.steelsoldiers.com/data/attachments/318/318074-f9405953d0c013e0b182f78e635d0ed0.jpg)
Last edited: