devilman96
New member
- 2,056
- 17
- 0
- Location
- Boca Raton, FL
Ha! Finally I quit avoiding some of the work I need to get to!
Some pics... I started my supports for my seats and the sub boxes that needed to go under them... I got this set from a 04 Monte Carlo and they have power everything to boot! The stock height on the deuce seats was 14 - 14.5 inches which I find to be to low for me so I am making the low point 15" on these by building a 7" 3 sided stand. I got the seat belts to boot and will be attaching them to the box so I used 1/4 x 6" flat bar and 1.5 angle for the mounting points...
I know I will catch some grief about the sub woofers but I had to have them and again... noooo BOOM BOOM!!! This thing will be balanced to play anything from Jerry Reed to Metallica when I am finished! The enclosures are .670 cubic feet in volume (per manufacture specs) and made out of .750 MDF, sealed with GE silicone, nail gunned, and then wood screwed together. The subs are made by Rockford Fosgate and are 10" Stage2 4 ohm woofers... I am SURE Bridgeport never intended a J mill to cut inlets in MDF but I have the worlds largest router!
I am holding off on finishing anything until I get them in the truck and can see what colors I want or need where (black and OD) should be a fairly nice and concealed set up when finished... At a minim they should make for a great butt massager! LOL
What else??? Clutch swap is planned for next weekend... Ken is going to drag the POS over on Saturday evening (again thank you) and I will HOPEFULLY have everything set to go for a Sat/Sun swap out... I will try to document the job as best as possible with pics... Would make a great "how to" I think...
Some pics... I started my supports for my seats and the sub boxes that needed to go under them... I got this set from a 04 Monte Carlo and they have power everything to boot! The stock height on the deuce seats was 14 - 14.5 inches which I find to be to low for me so I am making the low point 15" on these by building a 7" 3 sided stand. I got the seat belts to boot and will be attaching them to the box so I used 1/4 x 6" flat bar and 1.5 angle for the mounting points...
I know I will catch some grief about the sub woofers but I had to have them and again... noooo BOOM BOOM!!! This thing will be balanced to play anything from Jerry Reed to Metallica when I am finished! The enclosures are .670 cubic feet in volume (per manufacture specs) and made out of .750 MDF, sealed with GE silicone, nail gunned, and then wood screwed together. The subs are made by Rockford Fosgate and are 10" Stage2 4 ohm woofers... I am SURE Bridgeport never intended a J mill to cut inlets in MDF but I have the worlds largest router!
I am holding off on finishing anything until I get them in the truck and can see what colors I want or need where (black and OD) should be a fairly nice and concealed set up when finished... At a minim they should make for a great butt massager! LOL
What else??? Clutch swap is planned for next weekend... Ken is going to drag the POS over on Saturday evening (again thank you) and I will HOPEFULLY have everything set to go for a Sat/Sun swap out... I will try to document the job as best as possible with pics... Would make a great "how to" I think...
Attachments
-
21.5 KB Views: 3,472
-
38.7 KB Views: 3,428
-
32.6 KB Views: 3,412
-
32.5 KB Views: 3,390