Timber
Member
- 185
- 0
- 16
- Location
- Montgomery, AL
I'm going to add the factory dome light to my M1009. Does anyone know if the wiring harness is there in the roof or do I need to source one of those as well?
Thanks.
Thanks.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Dome light
- Thread starter Timber
- Start date
cucvrus
Well-known member
- 11,473
- 10,434
- 113
- Location
- Jonestown Pennsylvania
No wire in the roof. I have an Led light and the wires are neatly surface mounted in split loom and P clips.
GunnyM1009
Well-known member
- 354
- 530
- 93
- Location
- Roanoke/Alabama
I just put up a magnetic led work light that is about the size of your palm. Battery powered but the batteries last a while since its led.
Timber
Member
- 185
- 0
- 16
- Location
- Montgomery, AL
Thanks. I have all the A and B-pillar trim + headliner, so I'm trying to use all factory parts. I'm going to borrow your LED idea though and put one in the base.
cucvrus
Well-known member
- 11,473
- 10,434
- 113
- Location
- Jonestown Pennsylvania
I have a truck lite LED hard wired in the back civilian location of the fiberglass roof and in the center of the steel roof and under the dash. All are LED and it lights up like an operating room. They are all switched with the stock headlamp switch.
Timber
Member
- 185
- 0
- 16
- Location
- Montgomery, AL
That's what I've been doing as well. I've had this truck a good while now so I want something more permanent.
cucvrus
Well-known member
- 11,473
- 10,434
- 113
- Location
- Jonestown Pennsylvania
I can post a few pictures if you loike. I also ran a wire back for the third brake lamp on the roof and one for the license plate light. The license plate is mounted
on the roof rack. Double pictures. I don't know why. That is my contribution to the Rausch Creek firewood fund raiser. Have a great day.
on the roof rack. Double pictures. I don't know why. That is my contribution to the Rausch Creek firewood fund raiser. Have a great day.
GunnyM1009
Well-known member
- 354
- 530
- 93
- Location
- Roanoke/Alabama
I understand. That is permanent for me though. I dont want pillars or a roof liner and i hate seeing wires so that is my solution.
- 34,012
- 1,808
- 113
- Location
- GA Mountains
I installed an armored dome light in one truck to get rid of the little cheap magnet lights. Then I stumbled across a mini might-d. Light.
https://www.google.com/search?site=....2.11.2600.3.tZqB7pl6rAE#q=mini+might+d+light
I know it's not stock but it's 100 times better than the little magnet lights and 1000 time more useful than that factory hard wired dome light.
https://www.google.com/search?site=....2.11.2600.3.tZqB7pl6rAE#q=mini+might+d+light
I know it's not stock but it's 100 times better than the little magnet lights and 1000 time more useful than that factory hard wired dome light.
GunnyM1009
Well-known member
- 354
- 530
- 93
- Location
- Roanoke/Alabama
Do you already have one of these? How strong are the magnets? I am looking for something that it actually takes a little force to get off after its stuck on.
- 34,012
- 1,808
- 113
- Location
- GA Mountains
Yes, I have one and it stays put very nicely.
GunnyM1009
Well-known member
- 354
- 530
- 93
- Location
- Roanoke/Alabama
Thanks I may look into a couple of those for Gunny. I love the fact that they take AA instead of AAA or worse watch batteries.
PeeWeeQ
Member
- 161
- 4
- 18
- Location
- Altoona, WI
I did the same thing...It's Energizer, I think, and I got mine at Advance Auto for $10. Another benefit is that I can pull it off and take it with me for under-the-hood work too....
I found an custom van light and installed it in the factory position
overhead where the overhead light would normally be installed.
it has three lights the outer ones are on swivels with the center lights
up the entire cab but not as bright as the outer ones.
my mechanic ran the light wire straight to the rear view mirror
on the windshield then ran another line from the mirror to the
drivers side pillar then to the fuse block. Three switches on the
light to turn them on individually. My mechanic he's old school
tons of used parts stashed all over his shop, had the proper GM
plug with wire that plugged into a vacant receptacle in the fuse block.
All the wire is between the inner and outer roof I.E. Not visible, works fine.
overhead where the overhead light would normally be installed.
it has three lights the outer ones are on swivels with the center lights
up the entire cab but not as bright as the outer ones.
my mechanic ran the light wire straight to the rear view mirror
on the windshield then ran another line from the mirror to the
drivers side pillar then to the fuse block. Three switches on the
light to turn them on individually. My mechanic he's old school
tons of used parts stashed all over his shop, had the proper GM
plug with wire that plugged into a vacant receptacle in the fuse block.
All the wire is between the inner and outer roof I.E. Not visible, works fine.
Last edited:
nyoffroad
Well-known member
- 942
- 690
- 93
- Location
- Rochester NY
I found a red/white LED light from a cop car, works great and is almost to bright.