USAFjwag
New member
- 14
- 0
- 0
- Location
- Greenfield Indiana
I recently purchased a m1009, guy said it would fire right up if I put batteries in it. Well, I did and it did not start. I knew the guy I bought it from too..ANYWAY, I replaced the starter bendix because under inspection it definitely needed replaced. So I did. Today I put the started back in and went to crank it, and NOTHING! both batteries are good, but I noticed only my GEN 2 indicator is illuminated. Gen 1 was on momentarily a week ago, and then went off ever since. I was wondering what could cause the light to not come on? Upon starting I noticed the voltage gauge only goes up to about 20v with key in on pos. Also after I tried cranking it twice a little while ago, I noticed the wait light stopped coming on. Any suggestions??