Engine stands

[bones1]

What do ya'll use for a multifuel engine stand since they are so heavy? Any pictures and information on making one?

 

[rickf]

I have a rotisserie that us 151 guy's use for our vehicles. This one was equiped to hold the big engines. I will see if I can find some pictures. I know I took some when I picked it up.

Rick

 

[nk14zp]

OTC Revolver is a nice stand.

 

[hndrsonj]

Lower half of an engine can. With a little work you can even run one there.

 

[tm america]

Do a search there was a thread on this a little bit ago .. i think there was pics and measurements listed in there..

 

[clinto]

http://www.steelsoldiers.com/deuce/54048-multifuel-adapter-otc-engine-stand.html

http://www.steelsoldiers.com/deuce/25766-engine-stand-drawings-deuce.html

 

[gimpyrobb]

I just made a stand for a multifuel. I used 4x4 steel tube as its what I had on hand. The front was a piece cut to 36 inches. I welded a 13" piece on top of that. Then drilled 2 holes 5.25 inches apart. The front motor mount bolts up easy. The rear was a tad more involved. Again a 36" piece of tube. Then I cut 2 6" tubes (I think 6" I will double check this week.) and welded them standing up to the 36" part. Finally I welded some .25 thick bar stock 2" wide to the top of the 6" pieces. I will have to get lengths on those later, I can't recall right now. Pics will accompany the measurements. The motor sits rock solid!

 

[bones1]

Excellent information, can't wait for your pictures>