So after a successful recovery last night, arrived home in the dark I realized the M51A2 would not shut off by simply turning the ignition switch back to OFF. I looked everywhere for a typical diesel shut off knob to pull and found only this (circled in red). Is this where the knob should be? I had to stall it to shut it off.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Engine Stop Knob Missing?
- Thread starter SandBar
- Start date
Yes
M51A2 won't shut down
Just got my 1952 Mack M51A2 home this week. After new batteries she starts and runs. But when I pull the engine stop knob out it keeps running. Being new to this I don't know what "normal" is as far as how it should feel or how far it should move. The first picture shows the engine stop out...
www.steelsoldiers.com
Attachments
- 558
- 844
- 93
- Location
- Riverhead, NY
Engine Stop Cable I think.
Quick search of two vendors turned it up only for the 2-1/2 ton. Odd.
On fleabay I found this from one of those I searched however.
Quick search of two vendors turned it up only for the 2-1/2 ton. Odd.
On fleabay I found this from one of those I searched however.
- 1,715
- 3,845
- 113
- Location
- Hidden Valley, Az
Any tee-handle Bowden cable will work, just paint it OD. Just make sure it is long enough.
Napa, Amazon, eBay, eTc.
DG
Napa, Amazon, eBay, eTc.
DG
- 16,766
- 24,079
- 113
- Location
- Burgkunstadt, Germany
Perhaps a look in the Parts TM would not be a bad idea. Sometimes you get part numbers and NSN's that can lead you to the right part, and sometimes it even tells you how long a cable is supposed to be. Then you can find a longer one and shorten it. Sometimes a part can be different for almost like trucks, in the same series.