• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Fabricated rear bumper

HelluvaEngineer

Active member
191
82
28
Location
Atlanta, GA
My M1009 is going into the shop this week for final panel finish + bedliner exterior (yeah, I know) + new door and tailgate seals. I removed the bumpers front and rear (thank you plasma cutter.) While at the shop I am going to strip the front bumper and brush guard and refinish. The back bumper...I'm gonna fab some rectangular stock. Intend to install a cheapo class 3 hitch under it. The original bumper mounts have that offset of 30-ish degrees. I want my bumper to be square. Also, they stick out too far for the tow points. Any pointers? Otherwise I'll remove all the original mounts and put some 1/4" stock on the frame. Thanks for any opinions.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks