196thprober
Member
- 397
- 12
- 18
- Location
- Northeast Michigan
I'll have the usual:
Padlock sets, six and ten piece keyed alike.
Axle (bearing) nut sockets, 3", 3-3/8", 4-3/8" & 4-7/8" (for 2.5 & 5 ton trucks, and mosttrailers)
(if anyone needs other sizes, PM me and i'll bring them)
Slide hammers, for ground rods.
Other odds and ends
I'll be looking for:
Complete, operating winch set up (winch, cable, chain, pto, shaft, extensions, operating levers and linkage, etc..) for an M35A2..... for less than $300. Green preferred, but I'll settle for tan also.
319; do you have ground rods for the slide hammers? Or should I just get a wooden dowel rod from the hardware........... Would like a Rod/driver for the TUG, do you have a Number of the hammers?
Last edited: