gama goat transfer case

[frenchman]

hello
need more info on replacing the transfer case in my gama goat from someone
that did the job on their vehicle my maine concerne is the stud is it enough clearence in the hull to take it out with out remouving the studs and leave the front differencial in place
any help will very much appreciated
thank you
frenchman

 

[1958 M274]

http://www.steelsoldiers.com/gama-goat/63075-gama-goat-transfer-case-front-differential-change.html

There is enough room to slide the transfer case to the rear without removing the studs. Once it clears the differential input shaft, rotate it 90 degrees as shown in the thread I linked to above and lift it out!

 

[frenchman]

hello
thank you very much for everything this is lot's of help i will probably doing this this summer since mine still running good but it was so cheap to buy a new one from red river parts i decided to replced it, did you put one or two gasket on each side? the parts book call for four gaskets! again could you leave the front differencial suspended with a jake
in front of the hull with the axle attached to the front differencial i will be replacing the T/C only
your goat sure look good with the new t/c in place
again many thank's keep up the good work
frenchman

 

[no1_macleod]

it is tight to do with the trans in but if you pull the trans, it's alot easier. It's a few more bolts and you can inspect things better.

 

[frenchman]

thank you for your reply to my post got my t/c from blake at red river this will be a good sommer project
frenchman