Gamma goat windshield wiper Arm length

[Al Capone]

I can seem to find correct wiper arms for my goat . I still have orginal motors in my goat which does not take a nut to retain wiper arm. I need a over all length so I can figure out if some of the m35 wipers I'm seeing are correct length . Or if someone has correct arms ? Thanks

 

[country]

We stock these arms

Dave
www.easternsurplus.net




SP-1765 | M561 Gama Goat Windshield Wiper Arm
Windshield Wiper Arm for M561 Gama Goat 1 1/4 Ton
NSN #: 2540-00-081-9518
Part #: 11601582
$9.00

 

[Al Capone]

Dave I think u have the later style that is retained with a nut to hold arms on . Like I posted I still have orginal wiper motors and not the upgraded ones which use the nut to retain .

 

[m38inmaine]

Scroll down to post #368, last picture shows part number for the early wiper arms.

http://www.steelsoldiers.com/showthread.php?141472-Operation-quot-URGENT-RESTORATION-quot/page37

Edit: I looked at Eastern's and the NSN shown for the new style is what the PS magazine shows for the old style, perhaps PS magazine got it backwards.

 

[Al Capone]

Looks to be the same Wiper arm for the old m35 trucks. There is some used ones on eBay but they want $18 each shipping on them and they are used .they are priced ok but the shipping makes them expensive . The length matchs the length of the wiper arms with hole thru them

 

[m38inmaine]

I think you will find that the 5 ton arm will have a smaller diameter spline, the goat spline is fairly large, I would confirm that before I spent money on them.

 

[Al Capone]

My splined shaft on my goat which has the orginal style motors has a small setup about same size as this junk 74 corvette sitting next to it

 

[m38inmaine]

I have a new pair of universal arms designed to replace most military wipers, I'll dig them out and measure the spline and length.

 

[m38inmaine]

While reading through some old posts another member with your style of arms posted these numbers. Anco 4101/NAPA 60-750 correct fit but could not find a wiper blade to fit. Anco 4103/NAPA 60-725, used the wiper adapter from these on the 4101. Blade Anco 91-18.