Does anyone have any tips on removing and replacing the seals on the hard doors? I cant seem to get them removed successfully because they keep pulling apart and am left with a small strip stuck inside the channel. I would also assume putting the new ones in is going to be a blast as well. Any tips on putting the new ones in would be awesome.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Hard door seals
- Thread starter Aviator85
- Start date
- 4,397
- 4,181
- 113
- Location
- Brentwood, Calif
Drill the rivets out and remove the channels...then just slide them into the channel. The channels especially at the bottoms have to opened up a bit cuz they are Usually banged up a bit, that and at the corners.