Hertz gauge jumping mep804a

[Clinton2292]

Guess I can’t post a vid just photos. Anyway had some issues with the resistors and wiring on the 12 volt side downloaded manual and I managed to get all that straight and it runs great and put out power great, The hertz needle is jumping all around I’m thinking it’s a gauge issue as I put my field piece meter on the output and it sits perfect an 59.9 hertz. Should I even worried about it or let er rip I read somewhere there is a driver for this gauge not sure any advice from the experts thanks

 

[Light in the Dark]

I assume there is a frequency transducer like the 802/803 units, and probably in the TM for this machine is a testing diag for this part. The gauge will not effect performance of the machine, the gauges are there for operator knowledge only.

 

[Clinton2292]

I ma

I assume there is a frequency transducer like the 802/803 units, and probably in the TM for this machine is a testing diag for this part. The gauge will not effect performance of the machine, the gauges are there for operator knowledge only.

I may just install a aftermarket gauge so I can set the frequency and just abandoned the OEM gauge

 

[Scoobyshep]

I ma


I may just install a aftermarket gauge so I can set the frequency and just abandoned the OEM gauge

That's the best solution. You can usually use the existing wiring, just bypass the transducer

 

[Guyfang]

That would be the A7. Dont forget that one wire goes to the K5. So you cant just cut it out.

 

[Clinton2292]

That's the best solution. You can usually use the existing wiring, just bypass the transducer

thanks for the help