HMMWV M998 presentation across the Atlantic.

[foxtrot]

A glass of the rear door to a stain between polycarbonate and glass.
I did a cleaning test with isopropyl alcohol.
I only have the correct adjustment of the X-right rear door.

 

[HoveringHMMWV]

I have been following this thread with quite a bit of interest. But I now must ask, where / how did you learn your skill sets? You seem to be very proficient with the mechanics, body work, paint, etc.... Nice work!
- HoveringHMMWV

 

[foxtrot]

Je suis autodidacte.
J'ai commencé la reconstruction de véhicules militaires en 2009.
Mes connaissances proviennent des manuels techniques des années 50 et 60 notamment Dodge avec l'arme Carrier puis tous les manuels de M151, M880, M715 etc ...
Je vais au bout de mes réalisations en grande partie grâce à l'informatique.
Mon projet précède le HMMWV.

RECONSTRUCTION [URL unfurl = "true"] http://www.m715zone.com/vb/showthread.php?t=29903 [/ URL]

 

[foxtrot]

Found some worn high back hmmwv seats.
I'll do all the covers.
The seam and topstitching will be identical to the original one.
The weft of the fabric is comparable to the fabric of the back cushion.

 

[foxtrot]

Bad weather this weekend so I made all four seat covers.
I have to blast sand the frames and paint them.
The 0.98 inch green velcro was hard to find.
Only three seats, I'm looking for a fourth.

 

[foxtrot]

 

[Caactus]

Wow. Just....wow. Fine work you're doing.

 

[foxtrot]

The seat frames are primed and painted black.
The warning on each door is stuck.
The gripping tape sewn, the covers are finished.

 

[foxtrot]

 

[foxtrot]

Always something to do.

The base comes from Germany the antenna of Italy and the branch of antenna of the Netherlands.

 

[foxtrot]

Since January, the HMMWV has traveled 1300 miles.
I'm preparing to restore everything inside.
This morning it was the M715 to roll.

 

[foxtrot]

PIONEER TOOL RACK

 

[foxtrot]

Replacement of drive belt set.

 

[juanprado]

By the time you are finished , it will be better than a brand new.

Outstanding!

 

[frank8003]

what did you use the 19/32" open end wrench for?
I still have mine after about 50 years and have used it I think three times!

 

[foxtrot]

This wrench fits well, most often these bronze alloy nuts.

 

[Action]

what did you use the 19/32" open end wrench for?
I still have mine after about 50 years and have used it I think three times!

Most probably use it for the 1/2" on the other end.

 

[foxtrot]

No, I confirm 19/32
Tobash you are limited

 

[TOBASH]

No, I confirm 19/32
Tobash you are limited

???

 

[foxtrot]

???

You bet $ 100 with me ?