RJTM998
Well-known member
- 178
- 373
- 63
- Location
- North Carolina
Any idea how I would power this in my HMMWV? Correct cable? How were these powered in a vehicle? Thanks, guys!!
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
HMMWV Spot light power source?
- Thread starter RJTM998
- Start date
- 5,635
- 2,953
- 113
- Location
- Metairie/La (N'awlins)
Check post #42
Juan's M998 HMMWV
Pulse Tech Distribution System I have one of these in my m923 battery box and very happy with it. This is a sealed weather tight fuse box with 12v & 24v separate taps,storage for extra circuit breakers, and a battery pulse desulfating board. An external battery test panel and a large solar...
www.steelsoldiers.com
I made a power cable for work lights / spot lights on my 1083. I made a 35’ and a 40’ power cable. The work lights / spot lights I used are:
Military Work lamps 24 volt. NSN 6230-01-228-9577. P/N 1497550.
I plugged the power cable in to the 12 volt rotating amber warning light connector on the back of the cab. I replaced the 24 volt bulbs with 12 volt bulbs. You can buy a receptacle and wire it & mount it anywhere you like and plug your light connector in to it. I cannot see the Amphenol type connector on your work light but you can match up the receptacle end using that #. Here’s a list of material I used for the work lights I had:
1) Amphenol connector 97-3101A-12S-3S. This connector plugs in to the end of the work light.
2) Back shell clamp 97-3057-1004-1.
3) Amphenol protective cap (to keep dirt & debris out of the power cord when not in use. 10-825915-012.
4) Power cable 16/2 SJTOOW. I used 35’ and 40’. You can make your power cord as long or short as you want.
You could wire your power cable to a 12 or 24 volt source depending on what bulbs you want to use.
Military Work lamps 24 volt. NSN 6230-01-228-9577. P/N 1497550.
I plugged the power cable in to the 12 volt rotating amber warning light connector on the back of the cab. I replaced the 24 volt bulbs with 12 volt bulbs. You can buy a receptacle and wire it & mount it anywhere you like and plug your light connector in to it. I cannot see the Amphenol type connector on your work light but you can match up the receptacle end using that #. Here’s a list of material I used for the work lights I had:
1) Amphenol connector 97-3101A-12S-3S. This connector plugs in to the end of the work light.
2) Back shell clamp 97-3057-1004-1.
3) Amphenol protective cap (to keep dirt & debris out of the power cord when not in use. 10-825915-012.
4) Power cable 16/2 SJTOOW. I used 35’ and 40’. You can make your power cord as long or short as you want.
You could wire your power cable to a 12 or 24 volt source depending on what bulbs you want to use.