tankie88
Member
- 357
- 4
- 18
- Location
- Redruth,Cornwall,England
Any one know how the rear load floor is removed from a M1009.Mine needs a new one.Is it bolted or welded or a mix of both.I,ve trawled the TM's but says nothing about the load floor.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
How do you..............
- Thread starter tankie88
- Start date
wreckerman893
Possum Connoisseur
- 15,629
- 2,054
- 113
- Location
- Akenback acres near Gadsden, AL
My guess is that it was spot welded and sealed at the factory.
A lot of panels are being reproduced for those type vehicles.
You can cut the old panel out and mig weld the new one in......most of the time they are oversized to fit over the adjoining panels.
Not sure how available they are over on your side of the pond.
A lot of panels are being reproduced for those type vehicles.
You can cut the old panel out and mig weld the new one in......most of the time they are oversized to fit over the adjoining panels.
Not sure how available they are over on your side of the pond.