AllenEM
New member
- 270
- 0
- 0
- Location
- Allen, Oklahoma
I need a wiring diagram for a civvy K5 to show were the three wires coming out of the tailgate go to.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
I'm puting a power rear window on my M1009
- Thread starter AllenEM
- Start date
stampy
Active member
- 1,321
- 22
- 38
- Location
- Henderson. NC
PM Stump and ask as I can't remember but we did this to my 1009 the window works great!
- 5,637
- 381
- 83
- Location
- Spring Branch, TX
Not to steal the thread, but I'm planning on doing this also. I have a friend with an '88 Suburban and the window regualtor between that and the Blazer are different. Has anyone tried this switch?
- 34,012
- 1,808
- 113
- Location
- GA Mountains
Jimm1009 has done it too on his 09. God Bless you folks going to the PW. I have that same system in my 91 Burb and believe you me, as soon as I can I'm scrapping it for barn doors.
clinto
Moderator, wonderful human being & practicing Deuc
Staff member
Administrator
Super Moderator
Steel Soldiers Supporter
Supporting Vendor
- 12,596
- 1,132
- 113
- Location
- Athens, Ga.
Barn doors = only way to fly
jimm1009
Well-known member
- 1,165
- 71
- 48
- Location
- Louisville, KY
electric tailgate
Jimm1009 here and it is wonderful to have this option that the military ignored.
It is two power wires and one ground and all it does is switch polarity between the wires.
I am at work so I don't have the information but I can get it when I arrive home at 18:00 hrs. I do have the genuine chevy book at home so I can scan the page and send it to you as a PDF document.
I cut the body side plug from a wrecked truck and attached to my three wire harness so that I could remove the tailgate and not have to cut the wires as Chevy does in the factory.
I'll report back later tonight when I'm back in my A.O.
Jim
Jimm1009 here and it is wonderful to have this option that the military ignored.
It is two power wires and one ground and all it does is switch polarity between the wires.
I am at work so I don't have the information but I can get it when I arrive home at 18:00 hrs. I do have the genuine chevy book at home so I can scan the page and send it to you as a PDF document.
I cut the body side plug from a wrecked truck and attached to my three wire harness so that I could remove the tailgate and not have to cut the wires as Chevy does in the factory.
I'll report back later tonight when I'm back in my A.O.
Jim
AllenEM
New member
- 270
- 0
- 0
- Location
- Allen, Oklahoma
Only if we could.
jimm1009
Well-known member
- 1,165
- 71
- 48
- Location
- Louisville, KY
electric window
Barn Doors ??
I'm stumped here and DON'T laugh too loud at me.
Ha Ha
Jim, again
Barn Doors ??
I'm stumped here and DON'T laugh too loud at me.
Ha Ha
Jim, again
stampy
Active member
- 1,321
- 22
- 38
- Location
- Henderson. NC
I assume they mean side by side doors instead of a fold down tailgate.
jimm1009
Well-known member
- 1,165
- 71
- 48
- Location
- Louisville, KY
tailgate wiring diagram
It just came to me. I "think" that they mean the vent windows.
Most cars andtruck do not have them anymore but they will fold out about 200 degrees or so.
Am I right out there?? Please tell me yes or no.
Anyway, as promised, here is the genuine Chevy wiring diagram for the electric tailgate window.
My tailgate came from a burned out GMC Jimmy which is the same as the Blazer but with a GMC logo instead.
It is a PDF document.
I purchased a 4 space add-on fuse block and powered the two circuits through it but there are many ways to go with that. The non-GM switch was a 30 amp reversing switch that I purchased at a truck stop for big trucks.
Regards,
Jim, aka jimm1009
It just came to me. I "think" that they mean the vent windows.
Most cars andtruck do not have them anymore but they will fold out about 200 degrees or so.
Am I right out there?? Please tell me yes or no.
Anyway, as promised, here is the genuine Chevy wiring diagram for the electric tailgate window.
My tailgate came from a burned out GMC Jimmy which is the same as the Blazer but with a GMC logo instead.
It is a PDF document.
I purchased a 4 space add-on fuse block and powered the two circuits through it but there are many ways to go with that. The non-GM switch was a 30 amp reversing switch that I purchased at a truck stop for big trucks.
Regards,
Jim, aka jimm1009
acmunro
Member
- 532
- 4
- 18
- Location
- Reynoldsville,PA
Barn doors = two side by side doors. Suburbans could be had with either a fold down tailgate similar to the blazer or with side by side doors that opened out.