naehring2000
New member
- 8
- 0
- 1
- Location
- NH
Hi folks, I recently installed a remote start from Inova on my 803 and everything worked perfectly as far as the engine going through the process of starting up except when it gets to the end of the warm up period the contactor doesn't close. I'm sure I am missing some wiring as all the pictures I have seen online show terminal block 10 on the board being utilized where mine is not.
Is this where I need that relay kit that is talked about in the manual? I am not an electronics guy so this is a learning experience.
I have an email and a voicemail in to Peter at Inova since late last week but haven't heard back.
Any help is appreciated.
Is this where I need that relay kit that is talked about in the manual? I am not an electronics guy so this is a learning experience.
I have an email and a voicemail in to Peter at Inova since late last week but haven't heard back.
Any help is appreciated.