• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Installing a Tachometer!

150
12
18
Location
BNE, Oz
lots of aftermarket speedo setups designed to feed to rally computers, basically a prox counter setup, any rotating shaft (preferably keyed) could be set up... question is more how/where would you mount the readout....

Spock
 

Gamagoat1

Active member
746
44
28
Location
Kiowa, Colorado
If you'll look at the 353 above the bell housing on the right side, slightly left and above the fuel pump, there is a little port covered by a two bolt cover. Guess what, that's a tach port.
 
Last edited:

dmetalmiki

Well-known member
5,523
2,028
113
Location
London England
just got my forehead off the floor

Thank YOU than you thank you! tomorrow I WILL be makng / fitting / attempting to fit a rev counter to my goat. would be real nice if i can use an M series rev counter. dont know why "they" did not fit one in the first place. but I shall certainly be doing that as my vry next project.
 

kubotaman

Well-known member
Steel Soldiers Supporter
1,053
132
63
Location
RI/MI
Has anyone actually added a tach to a Goat? Could be mounted on top of the dash it seems.
 
Top