wehring
Active member
- 1,375
- 26
- 38
- Location
- Angleton, TX
I have been searching the forum with no luck. Does anyone have the part number for EXTENDED wheel studs? I need +1/2"
Thanks,
Justin
Thanks,
Justin
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Longer Wheel Studs
- Thread starter wehring
- Start date
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 757
- 113
- Location
- Cincy Ohio
Have you pulled one out and taken it to a big rig shop?
wehring
Active member
- 1,375
- 26
- 38
- Location
- Angleton, TX
Yes
Took one to NAPA and they said that they don't carry that size (got the blow off) so I decided to do my own homework
Took one to NAPA and they said that they don't carry that size (got the blow off) so I decided to do my own homework
- 26,246
- 1,179
- 113
- Location
- NY
Here's a chart with part numbers, http://www.aetnascrew.com/wheelhvy.htm
Offroadfabworks
Banned
- 1,331
- 5
- 0
- Location
- decatur alabama
try this stud. its a little over 1/2" longer. its a Euclid number.
Right, E-5719-R
Left, E-5719-L
Right, E-5719-R
Left, E-5719-L
wehring
Active member
- 1,375
- 26
- 38
- Location
- Angleton, TX
Thanks!
That is what I needed. Thanks!
Justin
That is what I needed. Thanks!
Justin
ucfjeeper
New member
- 172
- 0
- 0
- Location
- St. Cloud, Fl
If odiron.com doesn't have them, chuckstruck.net sells them. I would have to be red river parts, boyce equipment, or memphis equipment would have them as well.
SilentSpeedy
New member
- 25
- 0
- 0
- Location
- Coopersville, MI
Got the same problem, I notice on the given website they are offering 5 different lengths. There I don't know the original length I don't know which one's to order for my 5 ton.
Any one know the answer? My studs are about 1/2" shy of covering the lug.
Last edited:
Justin,
I got tired of messing around with changing out the studs so I came up with a diffrent solution: I was told in the past on this board to use Budd-caps.... but I just don't like the way it does not let the wheel bottom against the hub/drum face.
So I took the Budd-caps and machined them down on the back side to where the taper is gone and the cap will sit flat against the hub/drum face. Now it acts just like the stud on the outer wheel of a dual wheel set-up and the wheel sits tight against the hub/drum when installed.....just like it is supposed to.
Just make sure to use a carbide cutting tool on the lathe since the Budd-caps are slightly hardened. I also use blue Loctite when I put the modified caps on to the studs to prevent them from comming loose when I remove the outer nuts....
Soni