-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Looking for a fuel pump in New York
- Thread starter beehumvee
- Start date
papakb
Well-known member
- 2,285
- 1,185
- 113
- Location
- San Jose, Ca
Save yourself some money, this is the same pump:
www.carid.com
FYI:
I just did this job on a friends HMMWV and there's no good way to push the fuel pump actuator pin back up into the block without removing the mounting plate. The gaskets are readily available and fit 1955 thru 1995 GM engines and only cost a few bucks so bite the bullet and remove the plate. I used wheel bearing grease to hold the pin up in the block when I remounted the plate and it washes out after the engine warms up so it won't cause any problems down the line. Use a touch of Permatex Hi-Tack to hold the gaskets in place. A word of advice when you do this job, remove the right splash panel and have a long extension with either a 3/8 swivel socket or a universal with a 3/8 socket to put things back together. This allows you to tighten everything up reaching in over the frame rather than busting your knuckles on all the solid stuff in the neighborhood.
Reference picture 3 in this bulletin
Spectra Premium® - Mechanical Fuel Pump
Mechanical Fuel Pump by Spectra Premium®. On our website you can find and buy first-rate replacement radiators, fuel tanks, evaporator cores, intercoolers, and more top-quality Spectra Premium products. Spectra Premium SP1143MP
www.carid.com
FYI:
I just did this job on a friends HMMWV and there's no good way to push the fuel pump actuator pin back up into the block without removing the mounting plate. The gaskets are readily available and fit 1955 thru 1995 GM engines and only cost a few bucks so bite the bullet and remove the plate. I used wheel bearing grease to hold the pin up in the block when I remounted the plate and it washes out after the engine warms up so it won't cause any problems down the line. Use a touch of Permatex Hi-Tack to hold the gaskets in place. A word of advice when you do this job, remove the right splash panel and have a long extension with either a 3/8 swivel socket or a universal with a 3/8 socket to put things back together. This allows you to tighten everything up reaching in over the frame rather than busting your knuckles on all the solid stuff in the neighborhood.
Reference picture 3 in this bulletin
Last edited: