Looking for designs for air bag mounts for a bobber with dump bed.

[Trooperrob85]

Here's mine it has M105 springs and overloads. Would like to add freightliner bags for heavy haul days.

 

[simp5782]

You can use steer axle air lift bags from a FLD120 or kenworth they are in the 800 range for the whole kit from Randy's truck parts

Bags are good for 15k

Front Axle Loadshare Air Ride Kit By Canadian Loadshare

Raney's Truck Parts carries all the semi-truck parts and chrome accessories you could need to have any 18-wheeler, RV, or pickup looking better than brand new!

www.raneystruckparts.com

 

[Jbulach]

@tobyS is in the middle of a build with helper bags…

 

[tobyS]

A few details.

The block has a 5 degree taper to make the driveshaft be within a degree of parallel to the TC output. I made a drain hole to keep the pocket that the bolt through the spring would collect if not drained.

 

[Trooperrob85]

A few details.

The block has a 5 degree taper to make the driveshaft be within a degree of parallel to the TC output. I made a drain hole to keep the pocket that the bolt through the spring would collect if not drained.

Thank you sir that looks awesome!

 

[tobyS]

Putting that plate on the side of the frame about sheared my thumb off. I added an 11 x 3 x 10' X 1/4" plate and my jack shifted, wedging the plate between the frame, my hand and the tire. Anyway....the plate would help on a dump but it's probably too late for you. Just the area where the rear trunion was attached, had lost more than 50% of its strength from rust where the plate joins, is riveted, on my A3. Look for rust swelling on the frame behind that trunion plate.