M-1009 emblem

[Outlaw86er]

I didn't use any font, I just "freehanded it" in paint. I used other 80s Chevrolet pickup badges for reference. Fortunately GM had so many trim levels on their pickup trucks most of the letters were already there.

 

[my86m1009]

If you plan on making them, I would be interested and I'm sure a lot of others would be too. Looks amazing

 

[natem]

Ron needs a M1009 emblem.

It would look real sweet mounted on his wheel chucks.

 

[Outlaw86er]

I don't have the ability to make these, but if someone wanted to use the design I wouldn't have a problem with it. Ideally, I'd like to get some of the GM badges and measure them so that it would truly look like a factory badge. That's going for maximum accuracy though. wkbrdngsnw's looks good and he actually made his so kudos to him!

 

[wkbrdngsnw]

Got board again and I took Outlaw86er's drawing and tried to trace the shape. My efforts ended up a little off but not too bad. Don't know If I'm going to put it on there but if I do it almost looks good right above the other one.

 

[73m819]

I can really see a market for custom ID plates, like AMG M35a2, AMG M819, KAISER M51a1, ect., ect. done just like the CUCV M-1009 one shown, maybe a 3 piece set, one for the rear, and one for each side of the side engine panels

 

[islandguydon]

I would do 3 with the CUCV as pictured last. 1 on rear tailgate, and 1 on each front fender as factory. I give you 1 rep point and two thumbs up for your perseverance and ingenuity on a job well done..!

 

[porkysplace]

I think they would look better paint OD with sand or light green letters on camo trucks or sand colored with black lettering on tan trucks . The shiney metal / chrome look just dosen't look right on a MV.

 

[Outlaw86er]

If it helps, I uploaded the original high quality .png file to mediafire. My original intent was to let people play with the colors if they wanted, so I left borders between the colors. The trace that you did doesn't look bad at all!

Here is the link--> CUCV Badge.png