hemi348
New member
- 25
- 0
- 0
- Location
- Lubbock/TX
Hey guys,
I have a m1009 that just started to act up. When the key is turned to run nothing happens, no glow plug cycle no nothing. When the key is turned to start again nothing happens no noise other then the ignition switch click. This all happened instantly after working fine for the day.
I tried connecting purple and red wire on the relay, starter spun with no start.
No fuses blown on the box. I have read the TM but it did not lead me anywhere helpful. It is a stock 24v setup.
- I have checked the ignition ground and battery ground; Are there any other grounds I should check?
- Is it common for the ignition switch to go bad on these trucks?
- I have heard the glow plug chip goes bad on cucvs, could that circuit effect this? (I doubt it was this, as it was running recently and a very hot texas day)
- The fuse box seems to be in very poor shape, Is there a replacement avaliable?
Any other suggestions that could help me solve the problem would be appreciated.
Thanks,
Eric
I have a m1009 that just started to act up. When the key is turned to run nothing happens, no glow plug cycle no nothing. When the key is turned to start again nothing happens no noise other then the ignition switch click. This all happened instantly after working fine for the day.
I tried connecting purple and red wire on the relay, starter spun with no start.
No fuses blown on the box. I have read the TM but it did not lead me anywhere helpful. It is a stock 24v setup.
- I have checked the ignition ground and battery ground; Are there any other grounds I should check?
- Is it common for the ignition switch to go bad on these trucks?
- I have heard the glow plug chip goes bad on cucvs, could that circuit effect this? (I doubt it was this, as it was running recently and a very hot texas day)
- The fuse box seems to be in very poor shape, Is there a replacement avaliable?
Any other suggestions that could help me solve the problem would be appreciated.
Thanks,
Eric
Last edited: