M1009 problem

[kipman]

I have a problem, replaced the IP and injectors last night, got it running, has a hesitation off idle, stalls after bringing the rpms up, do not believe there is any air problems, old pump was set 3/16 to the right on the timeing marks, I set this one dead on, could the timeing cause this problem, it will start right back up after it stalls, seems ok at highway speeds. the problem seems to be at idle.

 

[yetti]

if it runs along at highway speeds the it may not be air. but it could be that the idle is just to low. are you getting any smoke? if so what color

 

[kipman]

no smoke at all, idles sounds good, I will change the timeing and see if that helps.

 

[Westech]

sorry i did not call you back kip..was on the road and working at the house (its in the sticks). I would bump the timing a tad and see how it sounds. It dose not take much or the timing to be off and will have running problems. That is the only thing I can think of that ould cause that besides a lift pump not giving it enought fuel.

 

[kipman]

You got a house in the sticks?, does this mean you found a kernal?