bobclausius
New member
- 11
- 0
- 0
- Location
- laramie WY
I have read many threads about the m101 trailers. This is what I did to convert my m101a2 trailer to a dump trailer and what I did for the lights.
The lights were very simple, but don’t mess with the blackout lights. I used a 1165 bulb for the bigger one and a 67 for the smaller one. The 24 volt bulbs work but are dim. Light bulbs are cheap. I had to move the wires for the lights so it could dump. To make it a 4 wire hook up, look at my pics. I think all of these trailers are the same.
The brake line on mine had a coupler at the pivot point. Got napa to make me a flex line so it would not break. Use dot 5 brake fluid to bleed brakes if you have to. The front bolts had to be removed so it can dump. You can get pins for it but I just made the holes a bit bigger and used the same bolts, for as much as I will use it for dumping. Get some blocks to put under it when it comes down so the pins or bolts can be put in with ease. Without blocks the trailer can go past the holes. Without a block, bring a crowbar. If you have a big load make sure that the lights don’t hit and break off. To dump, lock hand brakes and back up. That is it.
If you have surge brakes, backing up with a load can be an issue. You may need to put a pin through the holes to disable the the brakes when doing this.
In the state of Wyoming, any trailer under 1000 lb does not need a title. If it is less than 800 lb you can get small plates. cheap. My m101a2 is 798 lbs.
If you make one a dump trailer and like to take it camping, you can level it anywhere and then make a block for it. Look at my pics they will help much!
The lights were very simple, but don’t mess with the blackout lights. I used a 1165 bulb for the bigger one and a 67 for the smaller one. The 24 volt bulbs work but are dim. Light bulbs are cheap. I had to move the wires for the lights so it could dump. To make it a 4 wire hook up, look at my pics. I think all of these trailers are the same.
The brake line on mine had a coupler at the pivot point. Got napa to make me a flex line so it would not break. Use dot 5 brake fluid to bleed brakes if you have to. The front bolts had to be removed so it can dump. You can get pins for it but I just made the holes a bit bigger and used the same bolts, for as much as I will use it for dumping. Get some blocks to put under it when it comes down so the pins or bolts can be put in with ease. Without blocks the trailer can go past the holes. Without a block, bring a crowbar. If you have a big load make sure that the lights don’t hit and break off. To dump, lock hand brakes and back up. That is it.
If you have surge brakes, backing up with a load can be an issue. You may need to put a pin through the holes to disable the the brakes when doing this.
In the state of Wyoming, any trailer under 1000 lb does not need a title. If it is less than 800 lb you can get small plates. cheap. My m101a2 is 798 lbs.
If you make one a dump trailer and like to take it camping, you can level it anywhere and then make a block for it. Look at my pics they will help much!
Attachments
-
56.7 KB Views: 506
-
45.9 KB Views: 523
-
56.2 KB Views: 563
-
29.8 KB Views: 518
-
62.7 KB Views: 546
-
52.4 KB Views: 521