Steve92307
Active member
- 119
- 85
- 28
- Location
- California
I have a buddy driving from Ca to MI in an M109 Deuce. The truck wont go over 35mph anymore and he is in AZ. The truck has the 465 multifuel engine. Any info will help
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
.I have a buddy driving from Ca to MI in an M109 Deuce. The truck wont go over 35mph anymore and he is in AZ. The truck has the 465 multifuel engine. Any info will help
It started about 150mile into the trip and the fuel filters have not been changed..
Just fishing for answers...
• Did the problem start after getting fuel?
• Any chance of changing the fuel filter (wix 33113 possibly)
Parts List for filters etc are linked below:
Deuce Parts Quick Reference Spreadsheet
Ok guys, here is a spreadsheet I have worked up just to assist people on locating some parts on short notice via local stores as well as some others. If you have any parts you want to add send me a PM with the part number and who supplies it. This is just a test sheet for now. I am still...www.steelsoldiers.com
.It started about 150mile into the trip and the fuel filters have not been changed.
He is gonna change out the fuel filters first. I did run it out of fuel accidentally a couple days ago. He looked at all the wheels and other then an axle seal leak everything looks fine..
Be sure to check for heat coming off the brake drums (Looking for dragging shoes).
I updated my original post but just in case you missed that...
.He is gonna change out the fuel filters first. I did run it out of fuel accidentally a couple days ago. He looked at all the wheels and other then an axle seal leak everything looks fine.
That's what I'm hoping for. Thanks. Hope someone else chimes in if they have any other info..
Good deal! Maybe a little rust and sludge got picked up from the bottom of the tank.
I don't know if there is a wire screen inside the injector pump or not (like the Cummins has).
Hopefully somebody smarter than me can answer that question.
It's not stuck, that was one of the first things I askedJust throwing it out there...Is it stuck in low range? (Transfer case lever down)
What's the heat gun for?Do one thing at at time, filters first
Infrared Heat gun is His friend
Heat gun is cheap
Don't go on the road without it
Determine your level of heat stroke while repairing truck when it’s 107 degreesWhat's the heat gun for?
Heat gun = temperature measuring device to check temp of bearings and drums without having to touch them.What's the heat gun for?
Gotcha, Wes said your out in AZ. The guy with the Duece wants to get it towed back to Michigan. You interested?Heat gun = temperature measuring device to check temp of bearings and drums without having to touch them.
Gotcha, Wes said your out in AZ. The guy with the Duece wants to get it towed back to Michigan. You interested?
Thanks, I'll let him know what you can do. "update to the situation" He changed all 3 filters and was able to get it up to 45mph. Oil pressure is good, electric fuel pump is working, no leaks. He says it begs down a bit in 5th on a mild incline. The truck does have 11r20s on it and this is his first military truck, so with the altitude change and him being new to MVs the truck sounds like its performing as it should. Comments appreciated.My conjecture as to the cause of the problem -
The truck has been sitting not driven a lot. There's nastiness in the fuel system. He filled it with B20 biodiesel which is an excellent solvent. The B20 sloshed around for 4 hours. This cleaned much of the nastiness off the inside of the tank and lines and deposited it further downstream into the filters and perhaps worse.
As stated above, changing the filters is the first thing to do.
You mention the speed is limited to 35mph, but you don't mention what the rpm is doing. 35mph and a high rpm would indicate that you're losing the clutch or the rear main seal is dumping oil on it and making it slip.
35mph and a corresponding low rpm is a fuel or compression/power problem.