m35 ujoint help anyone???

[Lee Alessi]

can anyone tell me if 5704135 2920-00-075-0335 is the correct p/n for the inside snap ring ujoint for the drive shaft from the front-rear axle to the transfer case??? amazingly mine have deteriorated VERY rapidly in the last two weeks

 

[Lee Alessi]

spicer gear crawled under his and the driveshaft from the transfer to front rear (front duals) has the bolt on caps. anyone else???

if so, anyone have a spare one they will sell?

mine are so bad (i ordered the saturn ones... i hope they work) it sounds like someone hitting the bed with a BIG ball-peen hammer when you put it in gear and let off the clutch

 

[da_sgt]

Lee; about the only help I can give you is that my Tcase to First rear diff is also bolt on u-joints

 

[Lee Alessi]

hmmm, i apparently have a hermaphrodite truck

the driveshaft shop offered to duild me a new one for 1000. i left with the old one...

 

[da_sgt]

I hope as you were leaving that "shop" you had your driveshaft over your shoulder.....and turned to say see ya....but accidentally beaned him in the head with it :boxer: Thousand Bucks :freaked:

 

[MVtrucker]

My U-joints have caps (4), each held in place by two bolts. Same as the take out front shaft laying out there. I'd take a pic for you, but it's raining like crazy.

 

[da_sgt]

Well my front shaft has the snap rings holding in the u-joint caps.

 

[Trango]

yep, front is external e-clips (1410, I believe), but the Trans-Tcase is bolted caps, same as Tcase-FrontTandem. Dunno about interaxle, but I think it's e-clips like the front.

Bob

 

[spicergear]

All I've seen so far are bolted caps on the tranny to T-case jackshaft, bolted caps t-case to 1st position rear axle, outside snapring 1410's rear jackshaft and front driveshaft.