• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

M35A2 Lights

klq9386

New member
4
0
0
Location
arkansas
As I drive down the road the lights (interior and exterior) and turn off. After about 30 second (sometimes less) they come back on. I didn't know where to check from a ground / wiring perspective. Any help would be greatly appreciated.
 

NDT

Well-known member
Steel Soldiers Supporter
10,359
6,323
113
Location
Camp Wood/LC, TX
Circuit breaker inside the 3 lever light switch is cycling. It could be a momentary short to ground somewhere, too much load, or a weak circuit breaker.
 

Warthog

Moderator
Super Moderator
Steel Soldiers Supporter
13,774
231
63
Location
OKC, OK
And that breaker can not be manually reset. It is auto resetting
 

klq9386

New member
4
0
0
Location
arkansas
I dont know if it helps, but when it is acting up turning the switches off and back on it stays off. I dont follow where the circuit breaker is? Mind helping explain where I need to check?
 

Warthog

Moderator
Super Moderator
Steel Soldiers Supporter
13,774
231
63
Location
OKC, OK
It is inside the 3 lever switch. As far as I know it can not be replaced.
 

Bill W

Well-known member
1,985
44
48
Location
Brooks,Ga
Mine would do the same thing when I ran with the high beams on, weak thermal breaker ( as already mentioned )
was my problem changed out the 3 lever and all is fine
 
Last edited:
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks