m35a3 drive shaft lengths

[Kelly4x4]

Ok here goes ,I have A m35a3 and it needs drive shafts ,the problem is the proper length for the middle and front , they keep wanting to send me a2 shafts it seems am general moved the transfer case back 2 niches for the 3116 and longer trans,, can some one pleas tell me what the proper length are or please tell witch TM I can look in ,, your help would be appreciated,, Thank you,, Bill kelly

 

[Guyfang]

TRUCK, CARGO: FIXED SIDE, W/WINCH, M35A3 (2320-01-383-3850) (EIC: BHL); TRUCK, CARGO: FIXED SIDE, W/O WINCH, M35A3 (2320-01-383-2047) (EIC: BHK); TRUCK, CARGO: LONG WHEELBASE, W/WINCH, M36A3 (2320-01-383-2046) (EIC: BHN); TRUCK, CARGO: LONG WHEELBASE, W/O WINCH M36A3 (2320-01-383-204 (EIC: BHM); TRUCK, CARGO: DROPSIDE, W/WINCH, M35A3C (2320-01-383-2049) (EIC: BHQ); TRUCK, CARGO: DROPSIDE, W/O WINCH, M35A3C (2320-01-383-2050) (EIC: BHP).


The TM9-2320-386-24P will tell you what you want to know. But first you need to tell us what NSN your truck has. Then we can use the UOC, (Usable On Code) to find the right parts. So write the NSN for your truck here.

 

[fuzzytoaster]

9-2320-368-24P Pages 218-227 cover the shafts and subcomponents.

I checked the NSNs and PNs to try to find product dimensions but came up short. Just the typical new P/N, cost, etc.. On that note I'm parting out an A3 if want a used set.

 

[Kelly4x4]

the NSN 2320-01-383-2050 just a side note both of my a3 's are not military there civilian ,they where built and used by AM General for the H1 civilian support team and do not have a DOD Plate . I have sequential #s m35a3 SN #501067 and # 501068 I got them from Terry McClanahan when he shut down American Outfitters . i just had a shaft i got from Eastern rebuilt to find out it was 2 inches to long they sent me a a2 shaft ,so back to shaft pro and cut 2 inch out ,, thanks for the Reply ,, Kelly