theres some on page 3 in my webshots ( click below ) I was told its not correct but it worked fine for me and everything bolted right up to the exsisting holes in the bed side. Also in my " M-37 Misc" album theres a couple of pic's of the intake snorkle mount ( page 4 )
M-37 After pictures from military photos on webshots
Thanks for posting those pictures and the installation drawing. I have a mangled Fording Kit that I'm trying to sort out. A previous owner bent the pipes, brackets and even the side of the bed trying to make it fit! I looked at the installation drawing that you posted but they make no sense when I look at my kit and truck. For example, the drawing says to use a 3/8-24 bolt and nut to secure the front clamp but my truck has a bracket there that has two 7/16-20 threaded holes there! Also the drawing shows using a bolt going into a threaded hole (No nut called for) to secure the rear bracket. My truck has three holes in that area but none of them are threaded! So I'm wondering, were all M-37s set up for the fording kit or did some not have the nut plates installed or had nut plates installed for other purposes where there should have been only holes for use with the fording kit?
Also the installation drawing shows that with the exhaust pipe in the upright position the clamp clamps to the smaller exhaust pipe
below to heat shield! There's no way mine will fit like that! The heat shield pipe sits much further down than the one shown in the drawing. In addition, the clamp is much too large to clamp the smaller pipe. Is this just a mistake in the drawing or has anyone actually got one installed
exactly like the drawing shows?
Final question, when you remove the fording exhaust pipe is there an other tail pile that bolts to the exhaust flange under the bed or do you just run an open pipe?
Anybody have kit on there truck that can post some pictures of the valve arangement? And the bracket hook up on the back of the truck? Or maybe the instructions for the kit?
