That plate that is welded in there thick seems to be a tough job to get out in order to but this back in restoration mode, I have not heard of any MV shows in Oregon I might ask the guy that has the Halftrack he might know but he does not take his out much due to having it put on a flatbed in order to take it anywhere. His came with a quad .50 Cal mount and you sit in the middle of 4 .50 cals.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M37 Top
- Thread starter Rhodesia
- Start date
- 888
- 9
- 0
- Location
- Seattle, WA
Try looking here for club near you. If there isn't one close enough, call one of the people in the closest club and ask for a name of someone near you with a M37. I'm sure they will be able to help you.
http://www.mvpa.org/home/local-clubs/find-an-affiliate/
http://www.mvpa.org/home/local-clubs/find-an-affiliate/
Another Ahab
Well-known member
- 18,003
- 4,564
- 113
- Location
- Alexandria, VA
Because it's welded (and also that bead isn't looking any too good particularly), it's likely not a standard installation.
Likely if it was a production item it would have been bolted or something to be cost-effective. It looks "home grown", do you think?
Another Ahab
Well-known member
- 18,003
- 4,564
- 113
- Location
- Alexandria, VA
could be home grown, but since this is a former Marine Corps. vehicle maybe they did some mods to it, when I was in the Marines we did allot of off the depot mods to our Tanks in order to make it work better for us. Remember most if not all of the Marine Corps. Vehicles are from the US Army (No Offense) LOL
I think I can just buy another PTO half bar and turn it upside down the two holes will line up for the two screws I will just have a bent handle with a hole on top, it could work, I will have to improvise overcome and adapt, LOL