-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M66 stuck ring turret
- Thread starter 319cssb
- Start date
- 1,061
- 1,539
- 113
- Location
- Wilson County, Texas
I take it you have this in a FMTV from the picture?
Did it move free before you mounted it or was it on there when you got the truck? Is the gasket on there?
I installed one on my truck and found a few things that made it snag;
Did it move free before you mounted it or was it on there when you got the truck? Is the gasket on there?
I installed one on my truck and found a few things that made it snag;
Mine was entirely stuck when I got it. I used a forklift to install mine. So it was slightly less sketchy than your installation.
It freed up a bit when I took the ring cover off , which is held by a bunch of Phillips head screws. I used a small plastic bottle with CLP in it and worked the ring back and forth. Wherever it moved easily and slowly worked it into areas where it would stick. With a good amount of CLP it moves slightly easier now.
Would be good to see an exploded diagram of an m66 or a video of a restoration.
I am using the original canvas which I have sprayed with a water repellant. But the truck is inside anyway.
Last edited:
- 1,061
- 1,539
- 113
- Location
- Wilson County, Texas
Mine was very smooth and just had one small snag spot after install that was due to a bend in the cab that bad the gasket bulge and rub on some of the hardware. I pointed it out in the video. Only other issue is I'd like the brake handle to hold a bit better.
As I said , mine was totally seized. The brake handle stuck. With a lot of twisting left and right, it freed up a bit. There is a ring around the m66 . It has two hinge and a long Phillips head screw to tighten and loosen . Under that ring is a felt strip. I think it lubricates the roller bearing. But I’m not certain about that.
- 1,061
- 1,539
- 113
- Location
- Wilson County, Texas
If I recall, to really get it lubricated properly, you need to remove it from the truck and flip it, then take it apart. Somewhere on this forum I read that is how someone got theirs freed up good.
Last edited:
Yeah removing from the truck and flipping upside down is not going to happen. My installation is not as bad as yours. I chased all the bolts with a tap. Only one had issues. But I definitely won’t take the ring off again
- 1,061
- 1,539
- 113
- Location
- Wilson County, Texas
Sounds like just working it like you have is the best bet then. Good luck!
- 5,635
- 2,953
- 113
- Location
- Metairie/La (N'awlins)
FYI, If interested then download the TM asap as it can not be posted here as it is restricted and will probably get pulled.
- 1,061
- 1,539
- 113
- Location
- Wilson County, Texas
Yikes, didn't realize that.