M725 engine and trans cost/availability

[amgeneral72]

Looking for a front bumper and shackles here.

Anyone?

 

[dozenjeeps]

I am still looking for a takeout engine in the Wisconsin area if possible...........anybody know of one around??

 

[mbrosch]

I am about to pull the engine and tranny from my M725. They are very low mileage (8500 miles), work perfectly and are stone stock. I would love to have them go to a good home.
If you are interested you can send me a message... somehow. I have no idea how these forums work so be patient. I'll figure it out.

 

[dozenjeeps]

Hi, would be interested but I am afraid the shipping would cost me more than I can afford..........I am sure someone in your area would love to have your power train.........thanks..........craig

 

[mbrosch]

I have an extremely low mileage M725 in Phoenix that I'm about to repower. I would love to the this pristine Tornado etc go to a good home.

 

[oxcart area 51]

I second what George wrote. I got 5 of those silly engines and transmissions sitting in the back of a M35 right now. They were all free to me and I will let them go free. You have to get them out of the M35 though. I don't have a loader anymore.

Be patient and a good set up will appear close to you for not much money.

Hi Barrman, I am looking for the Tornado 230 CI engine. I am wonder if you steel have them and haw can I get my hands on them. Thank you Sr.

 

[oxcart area 51]

Hi mbrosch, I am looking for a Tornado 230 engine , wonder if yours steel available.
Thank You Sr.

 

[mbrosch]

Hi mbrosch, I am looking for a Tornado 230 engine , wonder if yours steel available.
Thank You Sr.

Sold all the M725 stuff so that I could restore my M151A1. So the answer is that I have no 725 stuff to sell or give away.
The up side is that it went to a good home.

 

[oxcart area 51]

Sold all the M725 stuff so that I could restore my M151A1. So the answer is that I have no 725 stuff to sell or give away.
The up side is that it went to a good home.

Thank You Sr. !!!!

 

[Barrman]

I do still have them. I also have access to a loader again too. I am not headed to the left coast with a trailer anytime soon though. PM me if you have some ideas.

 

[oxcart area 51]

I do still have them. I also have access to a loader again too. I am not headed to the left coast with a trailer anytime soon though. PM me if you have some ideas.

Hi, thank you for answering my request.
Can I ask you what condition this engines are in? Used As remove? or NOS?
Are they complete with accessories?

I slowly working on a project and I like to know what is going to cost me to get this engines to SO CAL.

Thank You !!!!

 

[Barrman]

One locked up. 3 running when pulled. I know one of the runners had a rear main seal leak because that is why I pulled it. The other engine was supposed to run when pulled but I never even tried turning the crank.

I think there are at least 2 carbs, 2 or 3 fuel pumps and brackets for si alternators along with military alternators. At least 3 transmissions bolted to the engines. Maybe 4. I haven't looked in a while.

 

[oxcart area 51]

Hi Barrman, Do you know any one coming to SOCAL ? what you want ($) for the engines?
Thank You !!!

 

[Barrman]

I am not aware of any empty vehicles headed your way. PM me here or on the Zone so we can figure stuff out.

 

[chrisrauch72]

I have a 725 now and am updating to bbc i have a motor if your interested its the 230 tornado thanks.

 

[snowtrac nome]

in Korea the rok army replaced the jeep motors with Nissan, and Isuzu diesels, those little trucks got around really good with decent mileage too

 

[snowtrac nome]

also most jeep motors use a ford input spline and bell housing, the only thing you would likely have to change is the pilot bering to bolt up a ford engine to it

 

[bcowanwheels]

I have a new old stock in the crate 230 if this helps