jlperryman
New member
- 5
- 0
- 1
- Location
- Black Hawk, CO
I'm looking for a M916 driveshaft. The one I need is from the transfercase to the first rear axle. Any help would be greatly appreciated.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M916 Driveshaft
- Thread starter jlperryman
- Start date
- 9,604
- 1,493
- 113
- Location
- mid- michigan
Put a ad in the wanted to buy forum of the classifieds , you will need to upgrade to a Premium membership . Classified ads are no longer allowed in the regular forums.
Premium Membership Explained
To upgrade your membership go to the resources section and click on "upgrade to premium membership" Then you can post this in the proper place.
Premium Membership Explained
To upgrade your membership go to the resources section and click on "upgrade to premium membership" Then you can post this in the proper place.
- 12,195
- 325
- 0
- Location
- gainesville, ga.
even under the old post count system you could not do a add, you only have a post count of 5
- 10,458
- 6,530
- 113
- Location
- Camp Wood/LC, TX
The driveshaft is almost too heavy to pick up and install by yourself. Check the Truck Trader for wrecking yards in Texas (Ft Worth area) who are parting out M920's and cut one down.
Hammer
Well-known member
- 1,483
- 398
- 83
- Location
- Winlock, WA
Even though they are very heavy, they are not that hard to install.
Just do one end at a time
