That’s cool sounds like a nice set up, sounds like I was lucky to have all my fuel filter canisters intact . I even had that bazaar fuel strainer in the first filter that’s so hard to come buy. I’ve found a fuel filter mount off eBay that has two spots for a filter/water separator. What’s nice it’s a conman thread pitch to. In fact it’s the same thread pitch as my airdog fuel pump on my truck so I can buy the same filters if needed . Fuel filter on my air dog is a 3 Micron absolute filter with a Baldwin fs 1275 . Only downside it seems that all these fuel filter bases are 1/2 ntp . Fittings on the generator are 1/4 ntp. Not a big deal I can alway use a bushing . But I’d rather not if possible.Several MEP 002A and 003A generators I bought at auction had the three military fuel filter assemblies completely missing. Amazon, NAPA, and ebay offer two section diesel fuel filter assemblies for less than $30. One filter section is for water removal (that section has a clear glass bowl so you can see if water is present) and the second filter section is for solids removal. The whole assembly will mount on the rail where the military fuel assembly was mounted. I added a 5/16 inch brass hose barb fitting on the output of the fuel pump and another 5/16 inch hose barb on the input of the two filter assembly. Ditto on the output of the fuel filter assembly and on the input of the inject pump. I installed 5/16 inch fuel hose from NAPA and hose clamps on each end. Unless you use VERY dirty fuel, this will work great. The fuel filters are easily removed for replacement.
Sent from my iPhone using Tapatalk