MEP-003A voltage and phase switch stuck

[tennmogger]

Thank you! I see this is from 'figure 1' in some manual. Can you share the manual number? These pages seem more like from a training manual. Good schematic!

 

[Guyfang]

From the TM. Color has been added. Might have been from someone here in the forum, might not. Can not remember.

 

[tennmogger]

Follow up to those helping: the transducer is good and is getting voltage in, and has voltage out, about 3.5 vdc. The freq meter has voltage so meter must be bad. Kinda back where I started but know the old transducer was bad too. Making progress and learning a lot. We did full service on the engine yesterday and drained fuel tank, fresh fuel. Genny starts and runs great, good output voltage.

 

[tennmogger]

Looking for advice again. Filter changes done but none of the new seals fit so have leaks. Used WIX cross refs. Do the Fram C1125PL fuel filters come with seals that fit the 003? Ditto Fram CH6PL oil filter? Second, searching for the spin on filter adapter kit. For the -003 yielded nothing. Maybe those kits are no longer available. Anyone know? Thanks! Ps, getting into a clutch replacement on the SO's FLU-419 . Yuck.

 

[Ray70]

Yes, the Fram C1125Pl and CH6PL are exact fit with the correct gaskets.
As for filter adapters you may want to look at my drop in spin on filter kit.
I had them in the classifieds a long time ago, but never kept it updated. but check here.

Mep-002A 003A 004A 005A Drop in Spin on Fuel filter adapter

Last week I mentioned developing an easy to use spin-on fuel filter adapter for use rather than the the WIX 24470 Here is a look at the first production parts off the CNC machine and mounted on my 002A for your viewing pleasure. These adapters drop right in place of the original Fram canister...

www.steelsoldiers.com

I've made a couple dozen of them and everyone has been very happy with the simplicity and ease of installation.
I also have oil filter adapters available.
If interested shoot me a PM.

 

[tennmogger]

PM sent.