sgarfa
New member
- 19
- 0
- 1
- Location
- udine italy
hello to all!, more then a problem, i ask for a question, in short when I apply a load (a welder) even if they are only 70\60% percent rated current , the frequency on the meter falls, it is normal?, because the welder does not reduce the power, now I wonder if something is wrong in the regulator inside the pump, there is some trick to verify the correct operation of the regulator, I haven't a certain load to apply, and I state that knurled knob is already turned..
many thanks in advance
ame
many thanks in advance
ame