The top fan on my MEP-701A does not come on when running the generator. The one on the side does. When I got the generator recently, one of the fan fuses was burnt. I replaced it, and the wiring seems intact, and it is plugged in. Is this fan by any chance on a temperature controlled switch? The fan does spin freely by hand. The fan on the side of the case does run at full speed. H..
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
MEP-701A fan
- Thread starter Milbikes
- Start date
RWG
New member
- 27
- 0
- 1
- Location
- Maydelle, Texas
The fan on top should run full time with the other one.
I have three of these generators, and all work the same way.
RG
I have three of these generators, and all work the same way.
RG
Timeline98
New member
- 24
- 0
- 1
- Location
- Northern CT
Hal,
Let me know what voltage the fan operates at. I may have one for you. The ones I have are 6" and either 24VDC or 120VAC.
Let me know what voltage the fan operates at. I may have one for you. The ones I have are 6" and either 24VDC or 120VAC.
Attachments
It spins freely. If I spin it with a screwdriver while the generator is running, it slowly coasts back down to a stop. I found a spot on the black wire going to it that had some bare wire. I don't think it was touching anything though. The fuse I had put in the other day is blown. Any way to bench test the fan? With four tiny pins in the connector it looks a little troublesome. H.
Isaac-1
Well-known member
- 1,970
- 50
- 48
- Location
- SW, Louisiana
I also have a problem with my top fan, it tends to build up moisture inside and stop working, every few months I have to remove the top panel flip the fan over and pour the water out, I turn it back right side up and it runs fine for another few months, getting all those screws out on the top cover is a pain though.
Ike
Ike