So I bought two 51R series batteries for my MEP802 and for the life of me I cant figure a way to secure them down. I heard the factory way was J-hooks yet I see no holes or evidence of them ever being there. Could some one please provide me with a picture of how your batteries are secured down from the factory. I did see the one post about using spray in foam and I'm not really looking to go that route. Thanks for all the help
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
MEP-802 Battery Hold down
- Thread starter CDR
- Start date
jbayer
Member
- 675
- 7
- 18
- Location
- St. Aug., FL/ McGrady, NC
In the same thread as the spray in foam, there's a picture of the plastic tray. "J" hooks go into the skid base.
Search "MEP-802 Battery Hold down"
http://www.steelsoldiers.com/showth...work-though-to-start-project-Documenting-here
post # 19
Oh, and did you look at TM 9-6115-641-24? It's in the TM section. Thanks to Guyfang.
It tells/shows you everything you need to know about installing the batteries.
Search "MEP-802 Battery Hold down"
http://www.steelsoldiers.com/showth...work-though-to-start-project-Documenting-here
post # 19
Oh, and did you look at TM 9-6115-641-24? It's in the TM section. Thanks to Guyfang.
It tells/shows you everything you need to know about installing the batteries.
Last edited:
jbayer
Member
- 675
- 7
- 18
- Location
- St. Aug., FL/ McGrady, NC
Glad that helped you.
By the way, I don't have an MEP-802, or know anything about them. I just like to practice my SS and TM searching.
I can always seem to easily find what other people are looking for, but I struggle finding what I'm looking for.
By the way, I don't have an MEP-802, or know anything about them. I just like to practice my SS and TM searching.
I can always seem to easily find what other people are looking for, but I struggle finding what I'm looking for.
Last edited:
- 16,662
- 23,800
- 113
- Location
- Burgkunstadt, Germany
The batteries set in a Plastic "boot". The hold down bar, fits on the inside of the battery, on the edge. When you tighten down the nuts on the "J" bolts, do not over tighten them, as the whole battery and boot will "kant", or maybe better said, tilt toward the outside of the set. Then they flop all about. Not nice. You are suposed to be able to regulate the pressure on the battery edge with the bottom self locking nut. It's a matter of feel and doing a couple of times. But once its right, its like glued in there. Rock steady.