MEP-803 fuel pump Length discrepancy

[Sidis8]

There is a tag but looking at the manual it’s for the year and serial number unless I’m reading it wrong. But then this tag doesn’t follow the scheme as is. Missing the model

 

[loosegravel]

Well that tag doesn't tell you much of anything does it? Did you by any chance find out if Sleeman & Hawken has the 1mm oversized pistons?

 

[Sidis8]

Well that tag doesn't tell you much of anything does it? Did you by any chance find out if Sleeman & Hawken has the 1mm oversized pistons?

Is there supposed to be a different tag ?

and yes on the pistons, they have them.

 

[loosegravel]

Is there supposed to be a different tag ?

and yes on the pistons, they have them.

Perfect, glad that they had what you need. I don't have a picture of the "normal" reman tag that we usually see on the side of the block. But it usually has all of the information that Ray mentioned above. I wouldn't be too concerned about it. As long as you're getting the correct size of parts that you need. The main and rod bearings should be labeled on the back side of each of the clam shells. Are you replacing them as well? I didn't hesitate to reuse the ones that I had on a couple of different occasions. They had very little wear on them.