MEP-803A skid mounting holes

[jaxbill]

Hello,

I looked through the TMs (that I know about) but cannot find a drawing of the MEP-803A that shows the exact location of the skid mounting holes.

I would like to build a dolly in advance of picking up my MEP.

Does anyone know where I can find this?

Thanks

Bill

 

[devilphrog]

Don't know the measurement, but when I built my dolly I just ran lag bolts through them. More of a slide protection than anything, the unit weighs 1100 pounds and isn't really going anywhere

 

[impi]

Page 2-6 on the Technical Manual 9-81150642-24

 

[jaxbill]

Thanks. I didn't realize that was depicting where the holes are. I've been looking for a drawing looking down on the skid. Appreciate it.

 

[impi]

Apologies - the above is not reflective of the mounting hole positions. Those measure 29.25" apart front to back. The skids on my unit measure 29.5" center to center.

 

[jaxbill]

Ok, thanks.

I went through all of the TMs again and not sure a good drawing exists.

 

[impi]

I just measured on my unit this morning - the TM's don't have the exact measurement.

 

[jaxbill]

Thanks. I appreciate you doing that.

 

[impi]

Just to further clarify. The 29.25" measurement front to back is from the center of the mounting hole. The 29.5" measurement is from center of skid to center of skid when measured from the front of the unit which is also approximately where the holes are positioned.

 

[jaxbill]

Ah okay. That makes sense now. Thanks