novaman
New member
- 70
- 0
- 0
- Location
- michigan/Livonia
I have an 803 and I noticed I have a clack noise that is intermittent and when its clacking it drops rpm just a little from 60hz to 59hz. Then it will go away and smooth out. Think its an injector or a lifter? I'm thinking maybe lifter. Sometimes its just on cold start up then goes away another time I heard it clack while it had been running for a bit under load. Shut it down cause i wasn't sure what it was. dead cranked it. No noise. started it back up no noise. Any ideas before i tear into it. I load tested it at 12kw for a few hours and held the load no problem even when i heard the clack but i could feel it was off.
The one in the video is the one that clacks. It started a little rough then smoothed out let it warm up and then it ran smooth no clack that time.
Found another use for these things. buddy was buying some cnc's out of a warehouse that didnt have 3 phase available so i rented it out to him for 2 hours to check em out before he bought em.
https://www.youtube.com/watch?v=MdMnq8amLgA
The one in the video is the one that clacks. It started a little rough then smoothed out let it warm up and then it ran smooth no clack that time.
Found another use for these things. buddy was buying some cnc's out of a warehouse that didnt have 3 phase available so i rented it out to him for 2 hours to check em out before he bought em.
https://www.youtube.com/watch?v=MdMnq8amLgA
Last edited: