MEP-805B reconfiguration

[czego82]

Can anyone please ahead some light on how to reconfigure then generator from 120 to 240v?
I know there is VOLTAGE SELECTION SWITCH behind the control board. Does anything need to be changed on the panel above where when L1-L2-L3 are?
There are little arrows that have volts on em, how to do switch that?
Thank you so much

 

[Light in the Dark]

Welcome to SS. Have you downloaded the manuals for this set?

 

[czego82]

Yes, all it has is this statement:
Ensure VOLTAGE SELECTION switch (9) is set to match voltage requirements.

I guess I should clarify my question...
How do I change Voltage Reconnection Terminal Board

 

[Guyfang]

The info you want is in the -10 manual. The switch is only for the control panel stuff. If you can't find it, LID or someone will help you. But first look. It's EASY.

 

[czego82]

I found the switch no problem. My only question is how to change the terminal board. Do I just unscrew all the nuts and move it up? Seems too easy

 

[Guyfang]

Yes. Remove nuts. Move board. Put nuts back on. Its in the TM. Don't make it hard.

 

[155mm]

Not knowing what the use of the genny will be, my question would be, are you sure you want 240v?

that is, 240v per leg, 416v across 2 legs, not 120v per leg, 208v across 2 legs